Punching machine

Nome do Produto: Punching machine

1.Parâmetro do produto

2.Instruction for use:

• Plug in the power switch turns the motor on and check the functioning of the device to confirm the normal operation, shutdown.
• V-shaped native cavalry base attached to the pipe, adjust the length of the chain, with the pin alignment and then tighten the other end of the chain of nuts so this machine is firmly fixed on the pipe.
• according to the provisions confirm pore size, suitable clamping device after opening.
• start the motor, confirm once again tapping machine, hole normal dynamic change.
• and pulled the (depressed) handle makes opening clamor slowly look down the opening in the correct position near the tube, on the contrary should be shut down and re-adjust the position after then boot.
• the opening, the pressure should be under the handle slowly and continuously cooled with coolant hole saw.
• after the opening off the motor, remove the machine. Handle with care machine can not drag on the ground.
• the company can provide a variety of hole saw.